[an error occurred while processing this directive]
TOYOTA LUCIDA/EMINA OBD codes
  
 
Specification Model Type Engine Type Model Year Detection Mode
JAPAN TCR10G 2TZ-FE 1/1992 - STANDARD
CODE DIAGNOSIS TRIGGERED BY ASSOCIATED AREAS
1 NORMAL 'Check Engine' warning light will flash continously to show that the system is OK. NIL
12 RPM signal 1 [G, Ne]
When no G or NE signals for over 2 seconds after getting STA ON signals.
* Wirings and connectors (crankshaft position & starter signal systems)
* Distributor
* ECU
13 RPM signal 2 [Ne]
When no RPM signal (Ne) to the ECU with engine speed above 1000 rpm.
* Wirings and connectors (crankshaft position signal systems)
* Distributor
* ECU
14 Ignition signal [IGf]
When no IGf signals to the ECU for over 0.3 seconds after STA ON (No continuous 4 sparks for over 0.3 seconds).
* Wirings and connectors (igniter +B, IGf, IGt)
* ECU
21 O2 sensor signal [Ox]
When O2 sensor voltage crosses the 0.45V line and is leaning towards either 0.35V (lean) or 0.70V (rich) side for over 60 seconds while the speed is below 100km/h.
* O2 sensor
* Fuel systems (injector, fuel pump)
* Ignition system (ignitor, plugs)
* Intake air system (vacuum sensor)
* ECU
22 Coolant temperature signal [THW, E2]
Whenever a short circuit or a circuit detachment in the coolant temperature sensor is detected, or coolant temperture exceeds 138 centigrade.
* Wirings and connectors (coolant temp systems)
* Coolant temp sensor
* Cooling system failure (overheat)
* ECU
24 Intake air temperature signal [THA, E2]
Whenever a short circuit or a circuit detachment in the intake air temperature sensor is detected for over 0.5 seconds.
* Wirings and connectors (intake air systems)
* Intake air temp sensor
* ECU
25 Lean error [Ox]
When no 'rich' signals were sent by the O2 sensor for over 90 seconds while the car is travelling at speeds under 100km/h with engine speed is above 1500 rpm.
* Wirings and connectors (O2 sensor)
* Fuel system (injector, fuel pressure)
* Coolant temp sensor
* Vacuum sensor
* O2 sensor
* ECU
* Coolant temp sensor
31 Airflow meter signal 1 [VS, VC, E2]
No signals from the airflow meter is detected for over 0.5 seconds while IDL ON and the engine speed is below 1500rpm with intake air ratio of below 0.025.
* Wirings and connectors (airflow meter systems)
*Airflow meter
* ECU
32 Airflow meter signal 2 [VS, VC, E2]
When the intake air ratio exceeds 0.09 for over 0.5 seconds.
* Wirings and connectors (airflow meter systems)
*Airflow meter
* ECU
41 Throttle position sensor [VTA, VC, IDL, E2]
Whenever a short circuit or a circuit detachment in the throttle position sensor is detected for over 0.5 seconds.
* Wirings and connectors (throttle position systems)
* Throttle position sensor
* ECU
42 Speed sensor signal [SPD]
When the speed sensor sent 0km/h signal to the ECU for more than 8 seconds while the engine speed is between 3000 rpm and 5000 rpm and the coolant temperature of 80 centigrade with the gear lever selected in positions other than P or N.
* Wirings and connectors (speed sensor systems)
* Speed sensor
* ECU
52 Knock sensor signal [KNK1, KNK2]
When a short circuit or a circuit detachment was detected in the knock sensor or its connectors for over 0.5 seconds while the engine speed is between 1600 rpm and 5200 rpm.
* Wirings and connectors (knock sensor systems)
* Knock sensor
* ECU
53 Knock management When the knock management part of the ECU fails for over 0.5 seconds while the engine speed is between 650 rpm and 5600 rpm.
* ECU
  BACK TO TOP
Other Toyota ModelsView repair reports of other Toyota models featured on this site.

ResourcesExternal links to specialist sites and related information resources.

Model ChartIf you are unable to find the repair report for a particular model, it may be listed under different names.
Back






| HOME | View repair reports | FAQ | Contact Us | Resources |

© 2013 MAD - Motor And Diagnosis
- Online Since 1st December 1999 -
http://www.mad-mechanic.com/